I didn't change any modules. I had CEM high already and as far as I know this is a requirement for forward parking sensors. Unless something was changed before by previous owner and I'm not aware of.
Volvo said they need to have electrician to work on the car. I don't want that as it is expensive and kind of not needed. I was planning to carry out total update, check Hybrid battery and then forget about Volvo service. Now I'm a bit stuck as I don't fancy disconnect the sensors wiring... Any idea how to proceed?
My mods are as follows:
- reverse camera OEM
- forward parking sensors including bumper harness and new wiring to CEM
- video recorder wired directly to 2 fuses next to passengers seat
- rear light with colour LED OEM
- speakers change OEM to DLS - just speakers plug and play.
All other mods were just software in Orbit.
FYI: just load the settings back from before Volvo dealer visit by Orbit and went really nice. So I don't know how would Orbit have access to car and Volvo not. I just assume it must be a different way of connection.
Wysłane z mojego CPH2581 przy użyciu Tapatalka
Volvo said they need to have electrician to work on the car. I don't want that as it is expensive and kind of not needed. I was planning to carry out total update, check Hybrid battery and then forget about Volvo service. Now I'm a bit stuck as I don't fancy disconnect the sensors wiring... Any idea how to proceed?
My mods are as follows:
- reverse camera OEM
- forward parking sensors including bumper harness and new wiring to CEM
- video recorder wired directly to 2 fuses next to passengers seat
- rear light with colour LED OEM
- speakers change OEM to DLS - just speakers plug and play.
All other mods were just software in Orbit.
FYI: just load the settings back from before Volvo dealer visit by Orbit and went really nice. So I don't know how would Orbit have access to car and Volvo not. I just assume it must be a different way of connection.
Wysłane z mojego CPH2581 przy użyciu Tapatalka