Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Drive Mode and Steering Personalization without Switch
#13
I tried it again:

03/14/2023, 11:19:36
ECM: U2300 - Central Configuration- System Programming Failures- Invalid / incompatible configuration - This is always there.
IHU:  U3002 - Vehicle Identification Number- Algorithm Based Failures- Signal compare failure                   - This can easily be cleaned.

I've tried to clear DTCs, Soft reset, and hard reset ECM+IHU in almost all combinations. Now I let the car for a few minutes to take the settings.
Dynamic/Polestar mode keeps the RPM at arround 1000 for a diesel car instead of 800 in Neutral. It doesn't quite sound well.

Looking forward to clearing those again and trying one more time after 8-12h. I've also added 374 (Polestar Optimization)
In terms of actual steering wheel changes, it doesn't work. No item from the menu is linked with the steering wheel pressure.
However, in Settings -> My car -> enable individual -> that steering wheel is applied somehow. (This menu wasn't there before)

Eco works
Off-road works
The other two do not work, and the steering wheel pressure is the same for all speeds.

Is anyone with an XC90 who activated this without having the hardware button?

The idea for admins, I guess this could be moved to "Engine / Transmission" since it modifies the way the car acts when you hit acceleration.
XC90 D4, FWD
Reply


Messages In This Thread
RE: Drive Mode and Steering Personalization without Switch - by muntes - 03-14-2023, 09:59 AM

Forum Jump:


Users browsing this thread: 8 Guest(s)