05-29-2025, 12:58 PM
I've read somewhere that with VIDA it's possible to activate gear number display in drive (so number next to D, not M).
It should last only for that session and should return to default (no display) after shutdown.
Is it possible to do this using OrBit?
And if it's possible is there any downside to this, does transmission enters some service/diagnostic state?
Would it be bad to drive with this enabled for longer periods?
I really hate no having that gear number by default.
It should last only for that session and should return to default (no display) after shutdown.
Is it possible to do this using OrBit?
And if it's possible is there any downside to this, does transmission enters some service/diagnostic state?
Would it be bad to drive with this enabled for longer periods?
I really hate no having that gear number by default.