Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Corrupted Data Received Message Failures- Alive / sequence counter incorrect / not up
#3
(05-09-2025, 07:46 AM)c3drus Wrote: Just sharing my experience: I had such errors when I played with the car on non-full battery and when the voltage drops below 12v under heavy load. What I do to prevent this now is that I charge the battery before reconfiguration session and in addition, I connect my 25A charger during the session to provide extra power in case the car system needs it. And it often does, especially during various operations through Orbit.

In the past when I got similar errors than you, I charged the battery, Cleared DTCs, Reset ECUs and drove a bit to get rid of them. But they disappeared gradually so you may need to iterate through above steps a couple of times Smile
I remember taking a mental note that the voltage ones at around 12 V when I did do the flash, which I usually don’t flash when orbit gives me a warning that the voltage was low, but it never gave me a specific warning telling me not to flash it’s been around a day now and I’ve tried clearing it as much as I can, and I’ve driven about an hour and I still can’t get it to go away. I’ve been doing that procedure for a while now I don’t have traction control stability control auto brake hold or any type of cruise control setting
Reply


Messages In This Thread
RE: Corrupted Data Received Message Failures- Alive / sequence counter incorrect / not up - by Arkman28 - 05-09-2025, 07:21 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)