Retrofit Keyless Entry

[Pliind]

Hi, I've decided to install the system. I've already purchased the handles and I'm clear on the CEM and connections.
My question is how to route the B-pillar cables?
Can you explain how you did it and how you removed the B-pillar trim?

Thanks!

B-pillar trim is easy, just pull on it from floor end  and pull down when all clips are free.

There are two waysa about this, oem route or diy route. I did oem.

Oem is pinning all cables to correct holes in b-pillar door connector and likewise in door harness (i swapped my whole door harness out)

Dit route is to drill holes in empty pin holes and pass cables through