03-15-2025, 11:03 PM
The wires coming out from the green connector. the connector should be numbered, you might need to take a picture and zoom in to see the small numbers.
Lower pins is the negative and upper ones are the positive.
C1 is negative and right above it C9 is positive. Should be the left front woofer.
C2 is negative and right above it C10 is positive Center Dash speaker.
When connecting the speaker make sure polarity is correct and other wires do not touch each other. You might have a balancer or filter in that box which might be polarity sensitive.
After connecting the AUD, you can check from Orbit under ECU tools TAB by sending different commands. Also scan for DTCs. Make sure you are getting response from AUD Start with trying to get the SW part numbers. If you so not get any results, that would mean IHU does not communicate with AUD.
Lower pins is the negative and upper ones are the positive.
C1 is negative and right above it C9 is positive. Should be the left front woofer.
C2 is negative and right above it C10 is positive Center Dash speaker.
When connecting the speaker make sure polarity is correct and other wires do not touch each other. You might have a balancer or filter in that box which might be polarity sensitive.
After connecting the AUD, you can check from Orbit under ECU tools TAB by sending different commands. Also scan for DTCs. Make sure you are getting response from AUD Start with trying to get the SW part numbers. If you so not get any results, that would mean IHU does not communicate with AUD.