02-18-2025, 03:23 AM
First of all, according to the picture.
Dark green (most outside). (C pins on the diagram)
1) Yellow (neg) + VT/BN (pos) Front Door right.
2) GY/YE (neg) + BN (pos) Front Door left.
You do not have center speaker output nor rear door speakers output on the AUD.
On the light green (in the middle next to power) (D pins on the diagram)
1) SPEAKER RIGHT D PILLAR
2) SPEAKER Left D PILLAR
Not sure if you have the speaker or they are just pre-wired. Pull out the cover and check if you have them.
There are two speakers on the dashboard. The small one is for warning sounds. Most likely you do not have the second one.
You are mixing up the settings. There are 4 variants in the config what you have is 01 Performance audio.
Your current AUD support 02- High Performance audio but you will need to wire sub and the rear door speakers.
Disconnect the dark green and measure the resistance. If you don't have a multimeter, just send audio from an external source to those pins to see what is actually driving the speakers, IHU or AUD.
When you change the settings, you might hear better sound because IHU changes the pre-amp software.
Dark green (most outside). (C pins on the diagram)
1) Yellow (neg) + VT/BN (pos) Front Door right.
2) GY/YE (neg) + BN (pos) Front Door left.
You do not have center speaker output nor rear door speakers output on the AUD.
On the light green (in the middle next to power) (D pins on the diagram)
1) SPEAKER RIGHT D PILLAR
2) SPEAKER Left D PILLAR
Not sure if you have the speaker or they are just pre-wired. Pull out the cover and check if you have them.
There are two speakers on the dashboard. The small one is for warning sounds. Most likely you do not have the second one.
You are mixing up the settings. There are 4 variants in the config what you have is 01 Performance audio.
Your current AUD support 02- High Performance audio but you will need to wire sub and the rear door speakers.
Disconnect the dark green and measure the resistance. If you don't have a multimeter, just send audio from an external source to those pins to see what is actually driving the speakers, IHU or AUD.
When you change the settings, you might hear better sound because IHU changes the pre-amp software.