Can s90 seats be fitted to S60

[AnttiH31]

Ah, okay. So in the worst case scenario I would’nt have all of the pins in my current seat controllers. Wouldn’t this just mean that I could get all of my current controls to work + ventilation but not the side supports and massage as the pins would be missing?

Yes,  but I wouldn't give up on side support and massage.  You can keep the seat controllers and before visiting the service, just disconnect the seat controller and not the main connector. So that you wouldn't get airbag light on DIM.  In addition,  you can attach a piece of paper, "DO NOT CONNECT"  

Also, is there ant chance you could help me with the installation instructions in VIDA? Mainly on how to swap the airbags

Here is a guilde how to remove the back cover of the seat.  And here is another one, scroll down in the forum. 

how to disassemble the seat belt to get the seats in and out.

The seat belt is hold in place with one big torque bolt.  Easiest way to do it is, remove the four bolts that holds the seats. Raise and move seat further so that you would have enough room.  you will need leverage and there is not much space between the seat and the side pillar.  You can use battery powered impact wrench to remove the bolt.

I’ve ordered the seats and they’re on the way. I don’t know for a fact if they have massage/side support but let’s assume that they do.

I’m a complete newbie on connector, pliers etc and I need more insight.

-On the seat connector, are the PINs numbered on the plastic connector or do I need to find a pin chart of the connector to know which PIN is number 15?

-What kind of crimping pliers do I need to crimp the PIN connector to a wire?

-How did you route the wire from the drivers seat to the fuse box? I’ve not removed seats from my car yet so I have no clue on how the looms are routed from factory.

-Looking at my cars owners manual, it says that Fuse 40 for seat massage uses a 5A fuse instead of 7.5A that I’ve seen on here. Which one is correct?

-The PIN connectors you’ve mentioned previously on here (https://www.amazon.com/dp/B0CH15J4BJ?ref...asin_title) are listed for 0.50mm2-0.75mm2. You’ve advised to use 18AWG wire which is 0,82mm2. Does the small difference matter at all?

Since the massage function is 1 wire per seat away from working, I’m keen to give it a shot.