02-11-2025, 03:17 PM
(02-10-2025, 06:51 PM)IMAY2023 Wrote: You are welcome.
After the hydraulic unit is replaced, VIDA will show two different software reloads under the Hardware change TAB.
One if them is BCM and the other one is the intelli safe assists.
You should only order and install the intelli safe assists, that includes all the required software.
Before doing that make sure an external power is connected to the car and voltage shows above 13 volts. Otherwise VIDA will not install the software and most importantly, "Once you retrieved, do not cancel the installation," otherwise you will need to reorder the same software again and ask for a refund for the previous one.
Let's say, you clicked on retrieve and then clicked on install after VIDA downloads the software. VIDA gave you error message "Connect external power". Even if you do not have one around, Leave the VIDA as is. Make sure laptop is connected to power until you found one. If you cancel the installation at that time or before hitting the install button, that's it. You will need to re order.
Make sure the external power supply is not low on battery (if you are using a portable one because it takes a while to install.
Thank you so much! Unfortunately, I live in the EU, and it's impossible to use VIDA on our own (I tried purchasing it via VPN, but my card was denied). However, I'll try to convince the dealership not to change the hydraulic unit and instead install the software. Also, it doesn't make sense that the software for the XC60 costs $2,500, while for the S60, it's only $500, I wonder why there is such a difference.