Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Multiple errors in xc40 after autopilot and adaptive headlight mods
#7
According to messages, you might be low on battery or there is something connected to car messing up the system. 
First thing, we need to get rid of the DTCs. 
Revert to OEM if you have not done so then clear all the DTCs.  Lock the car for about 10 to 15 minutes. 
Get back to car, drive about 10 to 15 minutes then rescan the car, you should not have any DTCs. 

Then, 
Step by step. 
Connect the CAR to orbit and update the profile.  It might ask you to enter CEM and VGM pins after that. So, please make sure you have them handy. 
Let's do the light first. 
Make sure your OEM setting is  106 - 0B Bending, Type A, w/HCM US/CND High Range. 
Change setting 
256 - BENDING LIGHT > with bending High and low beam. 
109 - ACTIVE HIGH BEAM > 05 with AHB2 (adaptive) High beam in Small village. 

write the config to car. Lock the car for couple of minutes then test. Check for the DTCs after driving. 

For the Pilot Assist. 


Check these again. 
238 - TOP DAMPING, BRAKES > 01 Friction brake actuator without top damping. 
314 - ADAPTIVE CRUISE CONTROL VERSION > ?
145 - TRAFFIC JAM ASSIST > ? 
382 = CREEP SETTING > ?
Reply


Messages In This Thread
RE: Multiple errors in xc40 after autopilot and adaptive headlight mods - by IMAY2023 - 02-10-2025, 09:59 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)