Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Adding motion / tilt sensors to CMA vehicles
#39
You also have 095 VISIBLE LOCKING/UNLOCKING

Quote:After i did those changes the "reduced alarm" did appear on the sensus screen ( i didn't enabled it ).
If it's enabled "green" it disables the IMS. 

Quote:After the settings changed should the car be left/driven ?

 Try to reset all ECUs.  Another possibility your CEM is low level and does not support it. 

Quote:How can i test the siren to see if it works ? 

Enable 070 PASSIVE ARMING.  Unlock the car, start the engine, (don't need to drive). Ignition off,  get out and close the door. Do not lock the car. Wait about 3 to 5 minutes. You should see the red light on the dash starts blinking.  Open the door without pressing unlock button on the remote key. You should hear the siren.
Reply


Messages In This Thread
RE: Adding motion / tilt sensors to CMA vehicles - by IMAY2023 - 02-08-2025, 01:32 AM

Forum Jump:


Users browsing this thread: 6 Guest(s)