Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Adding motion / tilt sensors to CMA vehicles
#38
Yes i have the red led blinking when the car is locked.
After i did those changes the "reduced alarm" did appear on the sensus screen ( i didn't enabled it ).
Will give it another shot tomorrow.
How can i test the siren to see if it works ? 
IMS should appear in the list of modules after the profile update correct ?
Is there any special setting for the siren ?
Shouldn't 096. AUDIBLE LOCKING FEEDBACK from Disabled to On make the sound when locked ?
After the settings changed should the car be left/driven ?
I bought both of the item used so i hope i didn't bought broken ones .. although bought from 2 different places .. so the chances of being broken both of them is very unlikely ...
Reply


Messages In This Thread
RE: Adding motion / tilt sensors to CMA vehicles - by ovidiu.stroe@gmail.com - 02-07-2025, 08:18 PM

Forum Jump:


Users browsing this thread: 7 Guest(s)