Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Adding motion / tilt sensors to CMA vehicles
#37
You can try,  07 PASSIVE ARMING . It will arm the alarm without even locking the doors.  Turn off the ignition, get out and just close the doors. Wait about 5 minutes and open the door, you should hear the siren. 

In the sensus main option menu (first tab) you should also have an option for the IMS. Make sure it's not disabled. "Green means reduced (IMS disabled)". 
Another thing, do you have the red light flashing on the top of the dashboard where the center speaker is after lock the car? If not, you might be missing that.
Reply


Messages In This Thread
RE: Adding motion / tilt sensors to CMA vehicles - by IMAY2023 - 02-07-2025, 07:10 PM

Forum Jump:


Users browsing this thread: 11 Guest(s)