Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Adding motion / tilt sensors to CMA vehicles
#35
No, if you already installed the IMS and the Siren in the engine bay, you can use the Orbit to enable them. 
However, you will need to revert the changes to OEM and disconnect them every time you visit the service. 
1) If you do not revert the config changes to OEM, VOLVO will block your car for any software reload. 
2) If you do not disconnect the Siren (Alarm and IMS). VIDA will detect them and force you to reload them and make them official before letting you to perform totol upgrade.
Reply


Messages In This Thread
RE: Adding motion / tilt sensors to CMA vehicles - by IMAY2023 - 02-07-2025, 06:43 PM

Forum Jump:


Users browsing this thread: 20 Guest(s)