(11-28-2024, 08:38 PM)BOSS89 Wrote: Very good InformationHi, there is no need to tear the light apart. I used my old light to see the internals and tried to figure out how would be possible to do something without breaking or opening the light.
I also disambled my front left light and took all modules out hopefully to find any corroded pins but I wasn’t successful.
All pins were in perfect condition
So I build all together. In the first 2 seconds it’s functioned perfectly but than it went again to the Center mode and no ABL.
So, do I need to completely tear down the headlight to adjust the screws?
Do you have any pictures from a little bit away?
Regards for your help!!!
I of course would like to mention that the thing I did might not work for others and it is not proven by anything, but at the moment the light is operating over the last 10 days and not a single stop has occurred. Please dont make me guilty if something goes wrong (i just tested some theory and as mentioned earlier then it could be related of me pushing the internal wires or totally something else that happened during this exercise and nothing to do with the vented air direction internally, but so far it works).
In any case you will need to dismantle the light from the car have it on the floor and wiggle the main connector loose ( there are very fragile 2 ears on the side that needs to be pushed in to loosen the connector), then push it into the light casing and try to push it aside towards the center of the light. Some force is needed, the opening needed is to be able to push in 7mm socket with swivel end to unscrew a little bit one of the screws. Then you need to drill a hole approx 5cm away from the connector towards the center with a size that would allow the same 7mm socket to go through to loosen the 2nd screw.
Once they are loose you need to use a thin flat screwdriver to move the module upwards and then tighten the screws again.
Only thing to remember is that the connector is very fragile so dont break it otherwise the light is ruined and you cant change the connector separately as it is connected from inside.
I can try to take some specific pictures, but as it allows only to add 4 pics then its a bit complicated.