Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Bending Lights and Active High Beam
#45
(03-02-2023, 06:25 PM)Power6 Wrote: So it looks like, for config parameters, you have no reported issue there (the invalid "106" was "05", but you are not using that, you have set "0C" or "12") which must be OK with the HCMs, so that seems like it's not the issue. But then what is...

Another thing to check, is on the CEM, check E103 as well. Probably nothing to see there, but you get a similar type of readout, more comprehensive. I know from experiece, anything here other than "all Zeros" would be a config compatiblity problem. Probably the issue is lower level, the config is fine but something in the HCMs don't like what is happening.

Code:
DID Result for CEM

E103 - Car Configuration Parameter Faults

Number of invalid car configuration parameter values recognised by CEM:
0


So no faults whatsover. 

Even when I restore it back to defaults it's giving me those HCML/HCMR invalid configuration faults. (I did not swap left or right)

Looks like it does not reset using Orbit.

I tried to disconnect the battery but unfortunately no luck. Any Ideas?
- MY2020 V60 T8 Polestar Engineered, Full options
Reply


Messages In This Thread
Bending Lights and Active High Beam - by mamous - 02-02-2023, 06:58 PM
RE: Bending Lights and Active High Beam - by x119 - 02-04-2023, 08:29 PM
Bending Lights and Active High Beam - by SlapShot - 02-16-2023, 04:03 AM
Bending Lights and Active High Beam - by BeachBoy - 03-01-2023, 11:47 PM
RE: Bending Lights and Active High Beam - by TweakeNL - 03-03-2023, 01:17 PM

Forum Jump:


Users browsing this thread: 7 Guest(s)