HP to HK Sound: Door Wires

[Pliind]

I actually had all terminals already from my keyless project so everything is now mounted and done! Sound is much better!

So you have the part numbers for the door / pillar connection?

Sorry i don't  i bought 4x harnesses and a couple of pillar connectors from the junkyard so i could extract the needed pins. My old harnesses gave me the extra pins for the doors i needed.

No problem! I routed the wires today, and did the bare wires inserted from the car side as recommended by IMAY2023. I don't have the door side receptacles yet, so I can't tell if it worked. But I'm hopeful. Getting to the front door harness connector from inside the car body is awful by the way.

Did you ever figure out the 6 and 8 codes? I did the HP to HK retrofit and have the same codes too.

After reflashing my amp from a v90 to v60 i now only have fault code for the subwoofer because ive connected the output to a external amplifier so the impedance is not correct. 
(i also undid the special reconnection in the rear door)