Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Adding motion / tilt sensors to CMA vehicles
#17
(03-07-2024, 01:20 PM)Muss Wrote: Hello. My car ,2019 XC40 D3 MOMENTUM FWD, came without an alarm, without IMS and without BBS. I purchased sh IMS and activated (65- 02interior movement sensor)  with car horn and works . When I wanted to install the BBS (siren with inclination sensor 31652494), I couldn't find the connection plug. At IMS, there was a connection plug in the ceiling light. 
 Where can I find the BBS connection plug or do I have to draw wires? 
 Has anyone encountered this problem? How did you solve it?
 Thank you

It's in the engine bay! There you go.

(08-23-2024, 08:05 AM)Aliaksandr Wrote: How to activate the siren in OrBit ?

064 ALARM > 02 ALARM


Attached Files
.pdf   instruction_VCC-451816-7.pdf (Size: 561.57 KB / Downloads: 22)
Reply


Messages In This Thread
RE: Adding motion / tilt sensors to CMA vehicles - by IMAY2023 - 08-23-2024, 04:12 PM

Forum Jump:


Users browsing this thread: 2 Guest(s)