Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Volvo XC40 B3 Mild Hybrid 2025 Changes
#2
(08-15-2024, 07:47 PM)Chally2 Wrote: I have a Volvo XC40 B3 2025 (Mild Hybrid)
I’ve tried enabling
 Lane Change Assist
Active Cruise Control 
Creep Option
Evasive Manoeuvre Assist

None of them seem to work, if I make changes to any of these settings I get multiple brake failure, parking brake failure warnings and a few others. 
Does anyone know if any of these settings can be safely changed?
Thanks
I don't know about CX40 but 
Lane Change Assist > Does not work. Leave it alone.
Evasive Manoeuvre Assist  > Don't change this. 
Creep Option > This is for full hybrid cars only. Mild Hybrid is a BS.  VOLVO replaced the regular starter and the alternator with a 48 volt generator that does both. 
Active Cruise Control > You mean adaptive not active.  
For this there are 3 main settings. 
023 CRUISE CONTROL > You can chose  04 or 07 that will give you ACC & PA. 
314 ADAPTIVE CRUISE CONTROL VERSION > Most of us have it on 01. Start from there. 
238 TOP DAMPING, BRAKES  > Official ACC / PA uses 02.  Check yours but do not change it. 
You can also enable curve speed support works while ACC or PA is engaged  For that you will need, 
148 CURVE SPEED SUPPORT > 02
145 TRAFFIC JAM ASSIST > 05

Orbit should run ABS clear config routine as post programming.  Make sure you do not have any checkboxes marked in "Export toolbox" tab. 
After configuration is done.  Disconnect the orbit "from the button" first. Turn off the ignition and lock the car for about 15 minutes. 
Start the engine and check for the errors. If there are any,  check and copy the DTCs to  notepad. 
Then, clear the DTCs and run  "ABS clear config" under services TAB.  lock the car for 15 minutes and check again. 
Hope this helps/
Reply


Messages In This Thread
RE: Volvo XC40 B3 Mild Hybrid 2025 Changes - by IMAY2023 - 08-16-2024, 05:47 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)