07-18-2024, 10:33 PM
I played with the WAM unit recently - second hand. Worked well.
Couple of thoughts.
First:
WAM unit has a software installed and there are two versions - PAC360 and PAC360 & BLIS.
If the initial car that the WAM module is comming from had BLIS enabled - you will have to enable BLIS in Orbit (along with PAC360 or reverse camer) in order for the module to work.
Second:
Although to see the camera option on the car infotaiment - it is enough to change the configuration in orbit (see point First) - if you want to do any diagnostics to WAM module - you have to click the UPDATE PROFILE button on the main Orbit screen.
It will add WAM module to the list of installed modules.
I do hope that it is still allowing to reverse to initial OEM configuration (did not check)
Third:
I did not make my camera to work. I only have 1 piece - this is the one with 6pins socket.
The camera does not show up - there is an icon of crossed out camera when i enable the 360 or revers cam view.
In the module diagnostics it is possible to read Serial numbers of all 360 cameras - all are FFFFFFFF in my case, so either a cable or camera is broken or - camera requires adaptation.
Question to Power6 - when I replace the reverse camera unit - do I need to adopt it in any way? If yes - can you please suggest what commands to send? (Thanks)
Couple of thoughts.
First:
WAM unit has a software installed and there are two versions - PAC360 and PAC360 & BLIS.
If the initial car that the WAM module is comming from had BLIS enabled - you will have to enable BLIS in Orbit (along with PAC360 or reverse camer) in order for the module to work.
Second:
Although to see the camera option on the car infotaiment - it is enough to change the configuration in orbit (see point First) - if you want to do any diagnostics to WAM module - you have to click the UPDATE PROFILE button on the main Orbit screen.
It will add WAM module to the list of installed modules.
I do hope that it is still allowing to reverse to initial OEM configuration (did not check)
Third:
I did not make my camera to work. I only have 1 piece - this is the one with 6pins socket.
The camera does not show up - there is an icon of crossed out camera when i enable the 360 or revers cam view.
In the module diagnostics it is possible to read Serial numbers of all 360 cameras - all are FFFFFFFF in my case, so either a cable or camera is broken or - camera requires adaptation.
Question to Power6 - when I replace the reverse camera unit - do I need to adopt it in any way? If yes - can you please suggest what commands to send? (Thanks)