Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
BLIS on iCup cars
#2
(06-10-2024, 04:49 PM)TomAmazon Wrote: Hi all,
I have a Volvo XC60 T6 er PHEV MY '22.5 and this was one of the cars where the chip shortage happened, so I don't have BLIS or CTA.
Is there a possibility to install these? Is the harness ready? Somebody did this already?
Hardware wise, if the harness is ok,  I would think the 2 sensors in the rear bumper and the mirrors. But secondhand hardware or new?
Software wise, I would think something has to be changed (by Vida or the dealer)?

I'm new at this, and only did config changes with OrBit and looked around.
Thx for the suggestions.
Tom

Have a look at this thread. 
Regarding the wiring, each build is different depending on the production week.  Sometimes it's prewired and sometimes it's not or partially wired like bumper harness has the connector but from the bumper to the ECU it does not. You need to check your car.
Reply


Messages In This Thread
BLIS on iCup cars - by TomAmazon - 06-10-2024, 04:49 PM
RE: BLIS on iCup cars - by IMAY2023 - 06-10-2024, 07:31 PM
RE: BLIS on iCup cars - by ChainedAlice - 06-14-2024, 06:26 PM
RE: BLIS on iCup cars - by TweakeNL - 06-21-2024, 01:57 PM
RE: BLIS on iCup cars - by Power6 - 06-21-2024, 02:10 PM
RE: BLIS on iCup cars - by ChainedAlice - 06-26-2024, 04:47 PM
RE: BLIS on iCup cars - by Power6 - 06-21-2024, 02:21 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)