05-07-2024, 12:13 AM
" Did something go wrong during the flashing process? Were you using Oribt?" At first it wouldn't flash due to some timeout. Then with the help from @Power6 that issue was resolved and according to logs from Orbit and the wireshark network dump, AUD did downloaded software but it would not run. When I check the F12E - ECU Software Part Numbers, it would return empty as if it's actually blank.
My second AUD (B&W) that I got from s90 gives me below.
DID Result for AUD
F12E - ECU Software Part Numbers
Total number of ECU Software Part Numbers:
02
SWLM:
31456884 AC
SWP1_Local Configuration Parameters:
31489579 AB
Raw hex data:
023145688420414331489579204142
DID Result for AUD
F120 - Application Diagnostic Database Part Number
Application Diagnostic Database Part Number:
31456247 AA
"I thought I had read that @Power6 had done it successfully?" Yes, he did but as far as I know, his used B&W AUD came from XC60 and he installed S60 B&W software on that used XC60 AUD. Both S60 and XC60 has the same audio output configuration. To be very clear, he warned me about the mismatch we both did not know the outcome and I took the chance; and now we know so that we can warn folks not to do this!
@Power, I noticed some AUD commands for configuration in the ECU tools tab, do you think we can send a command to AUD ECU to switch the output channels? Similar one for disabling or enabling the ACTIVE NOISE CONTROL.
My second AUD (B&W) that I got from s90 gives me below.
DID Result for AUD
F12E - ECU Software Part Numbers
Total number of ECU Software Part Numbers:
02
SWLM:
31456884 AC
SWP1_Local Configuration Parameters:
31489579 AB
Raw hex data:
023145688420414331489579204142
DID Result for AUD
F120 - Application Diagnostic Database Part Number
Application Diagnostic Database Part Number:
31456247 AA
"I thought I had read that @Power6 had done it successfully?" Yes, he did but as far as I know, his used B&W AUD came from XC60 and he installed S60 B&W software on that used XC60 AUD. Both S60 and XC60 has the same audio output configuration. To be very clear, he warned me about the mismatch we both did not know the outcome and I took the chance; and now we know so that we can warn folks not to do this!
@Power, I noticed some AUD commands for configuration in the ECU tools tab, do you think we can send a command to AUD ECU to switch the output channels? Similar one for disabling or enabling the ACTIVE NOISE CONTROL.