05-05-2024, 01:21 PM
(05-03-2024, 10:50 PM)IMAY2023 Wrote: DO NOT DO IT! Your AUD will turn into brick!
I tried the opposite way! My first AUD (B&W) came from S90 and I tried to load B&W S60 software on it to make my tweeters work.
At the end, AUD does not even load and turned into brick. Now I am trying to find s90 software to rescue it.
Although the the part numbers are all the same, most likely the AUD flash procedure requires config file to over write output configuration of the AUD similar to HCM (headlight controller). At the end of the day flashed software must match to the stored output configuration of the AUD.
You have two options.
1) Find an another AUD from any 90 series.
2) You need to connect your MIDs and Tweeters in parallel to the woofer.
Interesting. So you found the .vbf file for a 60 series and flashed it to the 90 series AUD?
I'm not that familiar with HCM / headlight swapping. But I thought if you were installing headlights from a different car you could flash to change the configuration?