05-03-2024, 10:29 PM
For the rear doors:
I bought this and used the 4 wires from the door to car connector with their pins. Not the big ones, the smaller ones. Then added them to the harness on the car. Using the 2 middle free ones on each door. The other side goes to the woofer connector. (i drilled a small whole right under the wire path.) You will see that woofer connector has 4 wires connected. (2 sets)
1 set is coming from the door connector from AUD, the other goes to the grey connector for the door trim harness for the tweeter.
So, you will need to cut the pair that goes to the grey connector and wire the two wires to them you just added.
The next step is from the AUD to the door connector.
This terminal is for the AUD pins.
I could not find the female pin part number for the door black connector. (the car side of the door harness that I bought) So, I trimmed 50mm the edge of the wire the push the naked part all the way into the whole for the female pin. (car side).
When you connect back the door connector (with the new male pins) it touches to the naked wire and that's it. Since the connector is locked in place and it's just very low voltage without any amperage there is no problem. You just need to secure the new wires with zip ties so they wouldn't push back.
I bought this and used the 4 wires from the door to car connector with their pins. Not the big ones, the smaller ones. Then added them to the harness on the car. Using the 2 middle free ones on each door. The other side goes to the woofer connector. (i drilled a small whole right under the wire path.) You will see that woofer connector has 4 wires connected. (2 sets)
1 set is coming from the door connector from AUD, the other goes to the grey connector for the door trim harness for the tweeter.
So, you will need to cut the pair that goes to the grey connector and wire the two wires to them you just added.
The next step is from the AUD to the door connector.
This terminal is for the AUD pins.
I could not find the female pin part number for the door black connector. (the car side of the door harness that I bought) So, I trimmed 50mm the edge of the wire the push the naked part all the way into the whole for the female pin. (car side).
When you connect back the door connector (with the new male pins) it touches to the naked wire and that's it. Since the connector is locked in place and it's just very low voltage without any amperage there is no problem. You just need to secure the new wires with zip ties so they wouldn't push back.