04-30-2024, 04:57 AM
Did anyone run into issues with Configuration Error (DTC from CEM) after the update?
I have a 24 V60 that was running AAOS 2.14.3 that I restored to OEM using Orbit before upgrading to 3.0.3.
I did not remember if there was any DTC from CEM after the restore to OEM before upgrading to 3.0.3. Only noticed after reapplying the configs post upgrade. Tried restoring to OEM on 3.0.3 again without luck and the DTC is still present, so I eventually re-applied the configs for now.
After running the E103 Active Diag ECU function against the CEM, it finds 1 invalid config for number 266, and value of 0. But I was not able to find any config numbered 266?
Also tried to clear DTCs twice but will always come back afterwards. Only moved the car around the parking garage and did not see any issues yet. Any insight?
I have a 24 V60 that was running AAOS 2.14.3 that I restored to OEM using Orbit before upgrading to 3.0.3.
I did not remember if there was any DTC from CEM after the restore to OEM before upgrading to 3.0.3. Only noticed after reapplying the configs post upgrade. Tried restoring to OEM on 3.0.3 again without luck and the DTC is still present, so I eventually re-applied the configs for now.
After running the E103 Active Diag ECU function against the CEM, it finds 1 invalid config for number 266, and value of 0. But I was not able to find any config numbered 266?
Code:
DID Result for CEM
E103 - Car Configuration Parameter Faults
Number of invalid car configuration parameter values recognised by CEM:
1
1st parameter number of the car configuration data that is invalid CEM.:
266
1st parameter invalid value CEM.:
0Also tried to clear DTCs twice but will always come back afterwards. Only moved the car around the parking garage and did not see any issues yet. Any insight?