Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Bending Lights and Active High Beam
#58
(04-11-2024, 10:59 PM)Orman Wrote: I don’t have bending lights but I changed 109 from ABH1 on/off to ABH2 adaptive High beam in small village. Adaptive high beam works but it’s not doing so much. It’s still kinda just switching normally between high and low beam. I can just barely see it turning off some light in the left corner when there is oncoming car coming. But it’s not shadowing or fading the light. 

Is there actual physical hardware missing in the headlight for this to function properly, besides the obvious bending light function?

Before I swapped my headlights with the bending ones. I tried the adaptive setting on the factory  MID LED headlights.  It does not do shadowing or moves the lights to the sides. 
All I noticed that, regular (on / off) and little bit dimming and aiming up and down.  I also noticed that the overall lighting is less with adaptive settings together with non-beny mid led headlights. 

With bending full led headlights, the adaptive high beam settings is operating very different. So far I noticed. 
headlights are moving side to side while going straight depending on the environment, (expending the illuminated area) 
Turns off or dims one side when approaching oncoming car. 
Lowers the headlights and dims the center when approaching another car from behind.
Reply


Messages In This Thread
Bending Lights and Active High Beam - by mamous - 02-02-2023, 06:58 PM
RE: Bending Lights and Active High Beam - by x119 - 02-04-2023, 08:29 PM
Bending Lights and Active High Beam - by SlapShot - 02-16-2023, 04:03 AM
Bending Lights and Active High Beam - by BeachBoy - 03-01-2023, 11:47 PM
RE: Bending Lights and Active High Beam - by IMAY2023 - 04-12-2024, 09:04 PM

Forum Jump:


Users browsing this thread: 9 Guest(s)