Can s90 seats be fitted to S60

[IMAY2023]

if its not electrical adjusted seats i think canbus will be missing on på 29-30 aswell.

imay2023

i have gotten everythin to work but in sensus im mising the graphical image about the electric "Seat extender" or as we call it i Swedish dynförlängning.

cem config is set to implement both seats. but i might have missed somting. do you have any ide

se image here. https://drive.google.com/file/d/1BEklZga...sp=sharing

Check if the seat actually has a motor to extend on passenger side, I heard some seats came with manual extension. 
Check the config setting 241. CUSHION EXTENSION >  With Cushion Extension, Driver & Passenger

If it's already set "With Cushion Extension, Driver & Passenger",  reset the passenger side seat controller and the IHU from the ECU tools tab. 
If still does not help, put the setting back to without or only on driver side.  Lock the car, wait about 10 minutes. Then reconfigure to both seats, lock the car about 10 minutes and then check if it works. 

When I first enabled the massage seats. the option was on the screen but did not work. I locked the car, came back about 15 minutes or so. Started the car, massage seats started to work.

---

So i just mounted my S60 electric chairs to my V60 momentum (manual chairs with heat) Only heat works in the new chair, cannot control the chair at all. I noticed that i have a connector in the chair that i have no equivilant to in the car. 

Does anybody know where and what this goes to? colors are green/yellow and green/violet(purple)


Also im reading up on all threads about this. Maybe i don't have it as i dont have massage seats but as chair will not move at all i'm looking at all resorts.

EDIT: I'm a master editor at this point. I found this image in another thread.

https://forums.spaycetech.com/attachment.php?aid=161

I have the same "new" but missing pin 15. So my seats do not need power i guess?
My original drivers seat only has 32, 16, 22 and 23.

So basicly
32: heating
16: power?
22: seatbelt reminder
23: seatbelt reminder

So I'm missing 30 and 29. I guess i'll have to go dive after purple/white, purple/green intertwined connector (are all this color and feature CAN?)

And keep reading about the airbags. If i have wrong airbags (from the seats original car), would that be a stopper to not being able to control seat? so a swap should do it?

On the connector of the car harness coming from floor.  
PIN 32 is the LIN communication of the seat heater module. 
PIN 16 is the Power (battery saver) (BU\GN) for both seats (PSMD & PSMP & Power seat switches) shares the same fuse  CF24 (B7- on the fuse connector harness)! 
PIN 30 and 29 are the body CAN.  You can connect them to the CAN wires of the door modules. 

I enclosed the full wiring diagram.  The seat connector number is "94/505"  driver side and "94/506" passenger side. 

Airbags on the seats has nothing to do with controlling the seats but there is seat position tracker sensor  which is used by the SRS (Airbag system). It is located on the side of the rail.  
127. SEAT TRACK SENSORS 
I don't know if manual seats have it or not. You'll need to enable that if your original do not have it. 

As long as your new seats have their airbags intact and not altered in any way, you should not have problems. 
If you buy a cheap seat because it has a blown airbag, you will need to take out your original airbag and the controller from the original seat and replace them on the new seat but I cannot say "it would work for certain"  You will be taking a chance here.