03-16-2024, 08:10 PM
Well, it's not that simple (plug and play) at least according to the diagrams.
4/172 FOOT MOVEMENT DETECTION MODULE FMDM on the rear bumper and it has two sensors connected to it.
You'll need power, ground, and LIN wires. Now, your rear bumper harness can be prewired for foot sensor module but there is a harness connector on the passenger side. Or you can replace yours with the one has foot sensor. Search in ebay, there are many of those.
That bumper connector on the car has the wires going to the CEM and other modules. That harness may not have the 3 wires for the foot sensor.
Ground (B3 on the module BK/WH) is easy, you can take it anywhere you want.
Power (B2 on the module Red) goes to rear fuse box CF52 = PIN B29.
LIN (B1 on the module WH/GN) goes to CEM PIN FL42. The good news is that it is the same LIN with 4/221 BATTERY MONITORING SENSOR BMS you can tab to that LIN wire.
4/172 FOOT MOVEMENT DETECTION MODULE FMDM on the rear bumper and it has two sensors connected to it.
You'll need power, ground, and LIN wires. Now, your rear bumper harness can be prewired for foot sensor module but there is a harness connector on the passenger side. Or you can replace yours with the one has foot sensor. Search in ebay, there are many of those.
That bumper connector on the car has the wires going to the CEM and other modules. That harness may not have the 3 wires for the foot sensor.
Ground (B3 on the module BK/WH) is easy, you can take it anywhere you want.
Power (B2 on the module Red) goes to rear fuse box CF52 = PIN B29.
LIN (B1 on the module WH/GN) goes to CEM PIN FL42. The good news is that it is the same LIN with 4/221 BATTERY MONITORING SENSOR BMS you can tab to that LIN wire.