Retrofit Keyless Entry

[Pliind]

Front doors

---

Soory for the format, but i have to resize them, and i'm  don't know how

No worries, i can help

This is the rubber cap inside the A pillar. Just extract, and then you can extract the connector inside the car
   

And this is on the driver side
   

The connector has a protection case that slide, and you have acces to pins
   

door hole
   

This is the foam isolation that has a window
   

I'm still confused about where to feed the new cables through as it looks like a complete connector with no "room" or are you connecting antenna + signal to the harness from the door and from the pillar? so they connect the "natural way"

---

Missed this image

This is the connector, on the exterior. You have to push taht pin and slide the connector inside the pillar