Retrofit Keyless Entry

[Sir0cco]

1. Hello. I started installing keyless on my car (2019 V60). At the moment, I have replaced the wiring harness in the doors, the handles and the rear antennas. I activated the keyless function and noticed that the rear handle lighting does not work. I replaced the front handles with the back and the LEDs are good. I checked and indeed they go to pin 8 and 23 in the door module. Does it have to do with the fact that I haven't pulled the wires for antennas and signal in CEM yet?
   

Are you sure you have enabled option 2 for leds- All handles? I dont have Orbit with me right now but is all handles is 2nd line option- 1st one is probably front only. 

If not - take multimeter and measure if you get 12v on any pin.