Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Center Speaker on High Performance
#3
I read that the centerspeaker was deactivated via software and could be retrofitted beforehand. That's probably why I only hear a minimal noise? So there's probably no chance of reactivating it again?


Gesendet von iPhone mit Tapatalk

(02-12-2024, 05:51 PM)IMAY2023 Wrote: What do you mean active from HK or B&W, By default the center speaker is already activated in both of those AUDs. 
If you have high performance AMP, (neither HK nor B&W), you can connect the center output pins.  (2 and 10). Either your AUD does not have center output or your wiring is faulty. (missing the ground / shorted / switched polarity).


Activate (you wrote and read active? and I wrote activate) on high performance.


Gesendet von iPhone mit Tapatalk
Reply


Messages In This Thread
Center Speaker on High Performance - by Duffy - 02-12-2024, 05:02 PM
Center Speaker on High Performance - by Duffy - 02-12-2024, 05:51 PM
Center Speaker on High Performance - by Duffy - 02-12-2024, 07:33 PM
Center Speaker on High Performance - by Duffy - 02-12-2024, 07:58 PM
Center Speaker on High Performance - by Duffy - 02-13-2024, 12:09 PM
RE: Center Speaker on High Performance - by Marcp - 07-19-2024, 07:09 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)