Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Adding motion / tilt sensors to CMA vehicles
#9
Guys, i'm trying to change the overhead console both front and back with the newer models. Already got them (with motion sensor-that is a different issue cause I don't have the connector for it) and the connectors don't match

The back ones both have 3 wire connector but the old one is bigger. The front one that is already on my car si wired with 10 terminals, 5 on top 5 on bottom but with a few blank ones

Does anybody know the connector number that I need? Is there a way to find the correct number?

Then there's the issue of pinout on the front light. The old connector has 2 bigger wires on both sides and 16 small in between and the new one has 3 big on both sides in a triangle and 10 in between. If the old and new both use the same color it could be easy but I think they don't

Btw: if someone has the time and wants to help me with pinout as well, just pm me and I can pay for the service. Thanks
2019 V60 D4 Automatic Momentum with AHB
ACC/PA/Backup Camera with OrBit 
Reply


Messages In This Thread
RE: Adding motion / tilt sensors to CMA vehicles - by marinalin85 - 01-05-2024, 01:03 PM

Forum Jump:


Users browsing this thread: 4 Guest(s)