Successfully programmed 2 sport keys (after replacing battery and printing cases) and one “normal” remote… a couple of times “no key found”, followed by “programming error”, finishing with “unknown error” which meant SUCCESS
![[Image: IMG-6808.jpg]](https://i.ibb.co/nDf7nSm/IMG-6808.jpg)
Not very good-looking cases, but there are no plenty of designs available for 3d printing them
![[Image: IMG-6808.jpg]](https://i.ibb.co/nDf7nSm/IMG-6808.jpg)
Not very good-looking cases, but there are no plenty of designs available for 3d printing them