Thread Rating:
  • 1 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Non-bendy LED to Bendy LED headlamps swap
#18
(11-18-2023, 11:25 PM)IMAY2023 Wrote: The easiest way, there should be part number on your current headlights. Search the EBAY with that part number. You can replace the same HW while using your own controllers.  You might need to manually adjust the aiming because those id*ts mess around with manual alignment screws! In general, you can replace your headlights with a different part number computable with your VIN and reload your current HCMs by using VIDA.  VIDA does not know if the headlights assembly are used or not! It only cares about the controllers and modified config in CEM.

Might not have to do any coding with the early lights.

I spent the last 3 months periodically searching ebay/Google for my PN lights and was not super successful. I found one that was basically destroyed, and one in so-so condition that the seller refused to ship. For most listings, sellers can't be bothered to list the part number so you have to dig through the pictures to find it.

I resorted to generic searches and found more than a dozen part numbers, most of which don't show up in volvo's online IPC at all. The only real hit I got was randomly from a reverse image search in Google photos.

The low beam module I ordered is apparently taking a full lap of the US before being delivered so I still don't know the status of the bendy motor in my light. I did fix all 3 alignment nubs on my current headlight, but my it still seems to be getting condensation from somewhere.
Reply


Messages In This Thread
RE: Non-bendy LED to Bendy LED headlamps swap - by Northern - 11-27-2023, 02:44 PM

Forum Jump:


Users browsing this thread: 10 Guest(s)