Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Adding 110/230V POWER OUTLET TUNNEL (VDN code: PG03)?
#7
(09-27-2023, 07:19 AM)FRANQ Wrote: Did you get it to work?

I found a 220v outlet at a local scrapyard, and it is very interesting for holidays to have 220v in the car.

Not yet, but looks I am very close to make it work ) will try to make it over coming weekends

Compared wiring of my car and car with 220v outlet and it looks that I need a connection to CEM (pin EN 35) for this plug to get ENABLE signal, as this pin is used to power up relay for other 12v plugs.

Fortunately other wiring already in the car, although by my VIN, VIDA not showing it.

So the plan is to make connection of gray wire 0.35 coming out of tunnel and CEM pin EN 35, and see if its working, fingers crossed )
Reply


Messages In This Thread
RE: Adding 110/230V POWER OUTLET TUNNEL (VDN code: PG03)? - by KentXRS - 09-27-2023, 12:52 PM

Forum Jump:


Users browsing this thread: 2 Guest(s)