Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
ACC/Pilot Assist Modification precautions
#8
Hello everyone,

I have a few (stupid) questions here.

I would like to install front side sensors as it is a "blind" zone when making a parallel parking.
I have even have places for them already in my Cross Country. I also have 4 front parking sensors from the factory.

I do not need the full Park Pilot Assist though.

Do you think it is possible to somehow wire side sensors to the side sensors?
Something like my sketch below.

I have sensors #1, 2, 3, 4. Let us call left side sensor L and right side sensor R.
Now I have four separate signals from 1, 2, 3, and 4.
I would like to somehow connect L to 1 (so the system would respond no matter which one is beeping) and R to 4.
As a result, CEM would think there are 4 sensors, but I will have information from 6: 1+L, 2, 3, 4+R.

Is that even possible? I would like not to screw everything, and I suspect there are complications related to voltage etc.
Any ideas? Thanks.
Reply


Messages In This Thread
RE: ACC/Pilot Assist Modification precautions - by estorsky - 08-14-2023, 08:03 AM

Forum Jump:


Users browsing this thread: 8 Guest(s)