Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Adding 110/230V POWER OUTLET TUNNEL (VDN code: PG03)?
#5
Continuing troubleshooting

Checked wiring from power outlet:
-          Red/Velvet (2.5 RD/VT) wire, comes to passenger side fuse box, at least it visible in pack of cables there. So I assume it should be connected to fuse #2, although I have not check yet if that’s so, fuse #2 (30A) installed from factory.
  On left plug coming out of central console its pin 8
-          Grey wire (0.35 GY) from central console, coming to CEM, EN plug, connected to pin 35 (checked visually looking into EN plug)
o On left plug coming out of central console its pin 10
 
   
 
-          Black wire, coming under passenger seat right from central console, to bolt to ‘ground’ connection.

Not checked yet:
-          Connection to engine fuse box from CEM.
o   It looks that gray wire (0.35 GY from scheme), should also reach engine fuse box, and it should activate relay (BR5 from scheme) that should activate power via read/velvet wire.

So question, does anybody has pin by pin plug description that coming to engine fuse box? Maybe from VIDA?

marked plug below on photo:

   
Reply


Messages In This Thread
RE: Adding 110/230V POWER OUTLET TUNNEL (VDN code: PG03)? - by KentXRS - 05-28-2023, 04:12 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)