05-24-2023, 09:12 PM
(This post was last modified: 05-24-2023, 09:18 PM by quattro4awd.)
(05-23-2023, 10:09 PM)Power6 Wrote: Note, I may have already said....don't freak out at the flashing TPMS "warning light" icon. It will be that way until learning is completed, then a message pops up on the IHU or DIM, saying "TPMS calibration complete" or something like that, then you are good!
exactly how long does one need to wait for the vehicle to figure out the sensors and perform a successful "calibration"? (I did a couple errands about 10 miles apiece.. total driving time around 30mins).
I have turned on the TPMS in sensus hit the "calibrate" button, system spins the wheel for 10-15 seconds and comes back with a "failed to calibrate, try again?" message. tapping "try again" pops up the hamster wheel again (10-15 seconds) and then the same "failed to calibrate, try again?" popup. turned off the TPMS in sensus, turn it back on to get the "calibrate" button to be functional again, run through the sequence...fails again (probably have done this 8-10x already). I have been trying to make sure the vehicle is moving while the hamster wheel spins, but it's still not picking it up.
It is acting like it doesn't see the sensors. I got the same velospinner (VS9070) sensors as seen in this post. do they need to be activated with one of the tire-shops handhelds to get them wake up and start transmitting? did you have to activate anything else in OrBit or add sensor ID numbers? Or did I do something wrong? currently the only changes from OEM are for the TPMS system
019 TYRE PRESSURE MONITORING SYSTEM
03 TPMS WBL US algorithm
020 TPMS MENU FUNCTIONS
08 With TPMS menu, shut off/show pressure/reset
267 INDIRECT TPMS SYSTEM
01 Without Indirect Tyre Pressure Monitoring System
everything on the sensus screen looks the same with the radio buttons as the image you posted other than instead of pressure value numbers at the wheel corners, it shows a _._