Service Procedure for SODL/SODR

[Pau1ey]

I'd like to re-calibrate Blind Spot Information System (BLIS) & Cross Traffic Alert (CTA) as CTA is not working well when reversing even though it's enabled, and there are no DTCs. I see a few options under Additional Service Procedures but cannot find directions on how to use any of these procedures. I'm guessing that I want to choose Side Object Detection - Reset Orientation Detection in SODL(eft)/SODR(ight) as the sensors were not replaced rather than Reset SODL/SODR to Factory? Thank you!

[spacey]

Following. I’m getting ghost warnings sometimes when a trailer is a attached and would love to try these out.

[Steffe]

Following. I’m getting ghost warnings sometimes when a trailer is a attached and would love to try these out.

They're disabled with a trailer plugged in, so not that surprising (nor a ghost error) 

[Pau1ey]

This is not as simple as beginning the procedure and driving like re-calibrating the 360 cameras - I received the following error messages, and no messages until these popped up. Unfortunately, this may be something that requires VIDA even though it's present in Orbit.

   

I did try starting the vehicle after clicking begin which gave me this error:

   

[harveje]

This is not as simple as beginning the procedure and driving like re-calibrating the 360 cameras - I received the following error messages, and no messages until these popped up. Unfortunately, this may be something that requires VIDA even though it's present in Orbit.



I did try starting the vehicle after clicking begin which gave me this error:

we have sodL/R issues  and received the same routine step 3 error.. Still searching in orbit and looking into vida..