Posts: 19
Threads: 4
Joined: Oct 2024
Reputation:
0
Hello,
after replacing seats from momentum standard to Rdesign, starting receive pop up message in cluster 3rd row right or left seat is not locked. Is it possible some home to disable this sensor? Or maybe can advise where to check it?
Posts: 756
Threads: 8
Joined: Feb 2023
Reputation:
61
I got the same message while messing around the CAN messages on my s60. I think, you seat modules of the R-Design seats are sending wrong message to CEM.
Try this.
Revert the config to OEM first.
Lock the car wait couple of minutes and then turn on the car check if you still get the message. If you are not, then enable the seat extension and other features that R-Design seats have and the original momentum does not.
Another point, usually momentum passenger seats does not have memory seats but R-Design seats have. You can check this by looking at the seat motors. Memory seats have 4 wires going to each motor while non-memory seats only have two. Do not enable the passenger memory seats if you do not have the memory buttons on the door.
If you still have your old seats, replace the seat controllers on the R-Design seats.
