Thread Rating:
  • 1 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Rear brakepad change
#1
Hi
How do i use Orbit when i change rear brakepads, can somebody tell me when i shall release the EPB whit Orbit.
Volvo XC60 2020 D4 AD-Blue
Reply
#2
Release the parking brake from the car, then start maintenance mode from Orbit... After replacing, exit maintenance mode.
Reply
#3
In addition, there is a setting in the menu to engage parking upon engine shut off. Disable that first and then put the brakes on maintenance mode from Orbit.
Reply
#4
IMAY2023In addition, there is a setting in the menu to engage parking upon engine shut off. Disable that first and then put the brakes on maintenance mode from Orbit.

Thx

(03-07-2024, 09:59 AM)danthe88 Wrote: Release the parking brake from the car, then start maintenance mode from Orbit... After replacing, exit maintenance mode.

Thx
Volvo XC60 2020 D4 AD-Blue
Reply
#5
What's does the maintenance mode in Orbit do? I've replaced the rear brakes on my MY16 XC90 and all I did was disable the parking break in the Sensus menu first and had no issues.
Reply
#6
You can up the piston using a 9V battery.
You can also do it with a wrench.

Both methods can be seen on YouTube

It's a very quick job to change rear pads

Sent from my Pixel 7 Pro using Tapatalk
Reply
#7
Hi, is the same procedure for the front pads?
Or is it not necessary to unlock the brake?
Reply
#8
(08-05-2024, 10:00 AM)Marcp Wrote: Hi, is the same procedure for the front pads?
Or is it not necessary to unlock the brake?

No EPB on front, not necessary.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)