Posts: 3
Threads: 1
Joined: Feb 2024
Hi I’m new here and planing to use OrBit on my Volvo XC60 T8 R Design Pro 2018. This may not be directly relevant, but I noticed even on Orbit tutorial it was mentioned you need to use battery charger when doing car diagnostic. Just wondering if CTEK MXS 5.0 12v 8 Step Smart Battery Charger will be sufficient enough with Output Voltage: 14.4v, 14.7v, 15.8v and
Charging Current: 5A. Would really appreciate your help. Thanks.
Sent from my iPhone using Tapatalk
Posts: 271
Threads: 11
Joined: Feb 2023
Honestly aside from using VIDA to do a huge software load, OrbIt I never plug in my car to play with simple changes.
Posts: 153
Threads: 5
Joined: Feb 2023
(02-21-2024, 11:34 PM)BeachBoy Wrote: Honestly aside from using VIDA to do a huge software load, OrbIt I never plug in my car to play with simple changes.
Same. Absolutely no need to do so for simple
changes unless you’re gonna spend 45 minutes staring at the screen pondering your next move.
Sent from my iPhone using Tapatalk
Posts: 271
Threads: 11
Joined: Feb 2023
(02-21-2024, 11:46 PM)Partridge Wrote: (02-21-2024, 11:34 PM)BeachBoy Wrote: Honestly aside from using VIDA to do a huge software load, OrbIt I never plug in my car to play with simple changes.
changes unless you’re gonna spend 45 minutes staring at the screen pondering your next move.
ahaha that's me.
Going in the parking garage for 30 seconds to swap one setting, ending up sitting in the car for 1h testing different functions.
Posts: 359
Threads: 4
Joined: Jan 2023
Yeah never plugged a charger in... never had an issue.
Advisable however if you do have one!!
Posts: 3
Threads: 1
Joined: Feb 2024
Thank you very much for sharing
Sent from my iPhone using Tapatalk
Posts: 890
Threads: 8
Joined: Feb 2023
Just make sure to turn off the headlights lights before switching on the car and you should be good.
