+- OrBit Forums (https://forums.spaycetech.com)
+-- Forum: Configuration Items (https://forums.spaycetech.com/forumdisplay.php?fid=3)
+--- Forum: Retrofitting (https://forums.spaycetech.com/forumdisplay.php?fid=13)
+--- Thread: Retrofit Volvo V60 B&W (/showthread.php?tid=24)
RE: Retrofit Volvo V60 B&W - jony - 09-14-2026
(06-19-2026, 08:22 PM)thermal-fixity Wrote:(04-07-2026, 09:16 AM)Marcp Wrote: Hey buddy!
Check this out:
Ref. 15498461
https://a.aliexpress.com/_EI4DIAM
Got it, thanks for the link!
For the rear door midrange/tweeter wiring, has anyone seen 94/509:8 already populated on the car-side plug? Is that wire actually used/prewired, or is it a blank/dummy wire that needs to be repinned or reused?
Hello, buddy,
a week ago I wired the midrange and tweeter in the rear doors separately. Put new pins in the both sides of the connector and that is the best way. Strongly recommend that.
Good luck
RE: Retrofit Volvo V60 B&W - billshoff2 - 11-03-2026
I'm going to upgrade my HP amplifier to a HK amp (part number 32265526 removed from a 2020 V60). I have a 2020 XC60 Momentum T5. It has Kicker coax brand speakers in the doors and a Rockville powered sub already installed. I'm looking for more power for the Kickers and more settings in the software.
If I understand what I've read, the one green connector from my HP amp should fit the new HK amp. My questions are:
1) Do I need to move any pins in the green connector to get my current speakers to work? Every door speaker is currently wired in parallel and I have no interest in wiring component speakers (separate channels).
2) I don't have a center speaker in the dash and I don't have ceiling speakers either....and I don't want to add them. So do I need the second green connector?
3) Do I need to add dummy loads (resistors) to the amp's speaker terminals that I'm not using?
Thanks in advance! Bill