+- OrBit Forums (https://forums.spaycetech.com)
+-- Forum: Configuration Items (https://forums.spaycetech.com/forumdisplay.php?fid=3)
+--- Forum: Safety (https://forums.spaycetech.com/forumdisplay.php?fid=6)
+--- Thread: Critical Issue After VIM Activation – Turtle Mode + DTCs Triggered (/showthread.php?tid=941)
Critical Issue After VIM Activation – Turtle Mode + DTCs Triggered - SebiC98 - 07-01-2025
Hi all,
I tried to activate Video in Motion (VIM) on my Volvo XC60 2021 with Sensus, and I set the option to "no speed" (so video could play even while driving).
Right after applying the coding, the car went into turtle mode (reduced performance) — I can't drive faster than 10 km/h. Also, several DTCs appeared, including ones related to:
- Battery/voltage problems
- Braking system (CMbB)
- Master cylinder piston position
- H-bridge / electrical circuit intermittent
Has anyone seen this before?
Could it be a wrong value in the VIM parameter? Should I revert to "stationary only" and clear DTCs again, or do a full ECU reset?
This was the flashing steps: From 03 Speed dependent -> 01 Never -> 02 Alway(All speeds) and now back to 03 Speed dependent
Any help or advice would be appreciated I’d like to have the VIM option, I already reverted and removed the DTCs but I am wondering why is this happening.
Thanks in advance!
RE: Critical Issue After VIM Activation – Turtle Mode + DTCs Triggered - x119 - 07-02-2025
You disconnected the cable and OrBit before testing?
Clear DTC and lock car for ~10 mins.
RE: Critical Issue After VIM Activation – Turtle Mode + DTCs Triggered - SebiC98 - 07-02-2025
(Yesterday, 10:31 AM)x119 Wrote: You disconnected the cable and OrBit before testing?
Clear DTC and lock car for ~10 mins.
Yes, ok I will flash again and test.