![]() |
|
Transmission Sound - Printable Version +- OrBit Forums (https://forums.spaycetech.com) +-- Forum: Configuration Items (https://forums.spaycetech.com/forumdisplay.php?fid=3) +--- Forum: Engine / Transmission (https://forums.spaycetech.com/forumdisplay.php?fid=8) +--- Thread: Transmission Sound (/showthread.php?tid=1240) |
Transmission Sound - juzzmee - 03-13-2026 Hi, Wondering anyone here encountered a clunking sound when engaging reverse from drive? When i engage reverse after car is in 'D', there's always a slight vibration followed by a rather loud 'Clunk', however, after 'R' is engage, vehicle will reverse normally/smoothly. I also noticed that if i put to 'N' first from 'D', wait a sec or 2, then engage 'R', the clunking sound will be gone or less noticeable, altho' the slight vibration will still be apparent. Seeking advise if anyone knows where should i start checking first? Read that it can be the transmission mount/drive shaft or the transmission itself. TIA RE: Transmission Sound - juzzmee - 03-16-2026 (03-13-2026, 06:22 AM)juzzmee Wrote: Hi, Does anyone know what is the typical part of the transmission mount to change? I searched and found there are like so many parts involved, like side mount, mount, torque arm, rear mount, etc? Really appreciate some input pls. thanks. RE: Transmission Sound - paunionutz - 03-16-2026 I assume you have XC40 (from your diagram) 1. Engine upper mount 2. Gearbox upper mount 15. Lower engine antiroll mount 17+19. Lower gearbox antiroll mount (19 has a small bush) 9. Bracket for 1 12. Bracket for 15 RE: Transmission Sound - x119 - 03-17-2026 Closing - not an OrBit related question. Please use one of the many other Volvo support forums for troubleshooting etc. Thanks! |