+- OrBit Forums (https://forums.spaycetech.com)
+-- Forum: Configuration Items (https://forums.spaycetech.com/forumdisplay.php?fid=3)
+--- Forum: Retrofitting (https://forums.spaycetech.com/forumdisplay.php?fid=13)
+--- Thread: Adding motion / tilt sensors to CMA vehicles (/showthread.php?tid=217)
RE: Adding motion / tilt sensors to CMA vehicles - ovidiu.stroe@gmail.com - 02-08-2025
Did the test.
With passive arming i can hear the siren ...
I have enabled alarm and with motion sensor but now I have an dtc Battery Bacup sounder , system internal failure, incorrect component installed.
This is the part nr I have : 31652388
For the IMS it seems that it is not detected ... though I would assume an dtc will be set if this wasn't detected ...
Any hints on this one?
Thanks !
RE: Adding motion / tilt sensors to CMA vehicles - IMAY2023 - 02-09-2025
According to part number " 31652388" the siren does not have level sensor. So, if you enabled the 066 INCLINATION SENSOR, disable it.
The IMS works with the Siren, if you set the above setting wrong, it might disable it
RE: Adding motion / tilt sensors to CMA vehicles - ovidiu.stroe@gmail.com - 02-10-2025
I managed to make make the error go away by setting 066 INCLINATION SENSOR enabled ( with ).
After an update profile the IMS is detected and the alarm triggers.
I have no audible notification when lock/unlock. I have only visible ( flashing ) ..
Stupid me .. forgot to activate it from settings.